"Clip total bitrate too high for a DVD video" is the message I get when I go to compile the DVD

[Rags847]

I am using TMPGEnc DVD Author 3 with DivX® Authoring version 3.05.149.
The bitrate is too high for the video portion. > 10000

Any tech help would be much appreciated!

Thanks in advance.

Rags

[AAR.oner]

depends on whether yer authoring the audio as LPCM or AC3, and it depends on length of the video as well...typically, i encode a 1.5 hour show ~8-8.5Mbps for the video, and LPCM audio [1.5Mbps]

[Rags847]

Thanks Aaron.

All is rockin' now.

Rags

[DanielG]

typically, i encode a 1.5 hour show ~8-8.5Mbps for the video, and LPCM audio [1.5Mbps]

You're not going to fit 90 minutes at those bitrates onto a DVD5.

Rags847: You should use a bitrate calculator before you encode your video. Try this one: http://dvd-hq.info/Calculator.html

[AAR.oner]

You're not going to fit 90 minutes at those bitrates onto a DVD5.

Rags847: You should use a bitrate calculator before you encode your video. Try this one: http://dvd-hq.info/Calculator.html
correct, shoulda specified...i'm usually authoring to DVD9...and i agree, you should get a bit rate calculator Rags