The Traders' Den  

  The Traders' Den > Where we go to learn ..... > Technobabble
 

Notices

Technobabble Post your general Need for Help questions here.
Lossy or Lossless?
Moderators

Reply
 
Thread Tools
  #1  
Old 2010-12-11, 05:09 PM
Egg_Crisis Egg_Crisis is offline
0.00 KB/0.00 KB/---
 
Join Date: Dec 2010
Question about weird looking wave

Both screenshots represent the same piece of audio, both are ripped from the same boot by two different people. It represents the end of one song, some audience sounds then the start of the next song.

This first one is how the wave should look when ripped properly...




The second one has had the levels increased, but it's not simply been normalised - you can see the audience bit has somehow been boosted to maximum volume so the entire wave is one messy splodge of horribleness.



Question: How would someone have made the wave look like this?

Is there a setting on some cd ripping programs that through a users incompetence could accidentally make the wave look like this, or is it more likely the audio has been deliberately & maliciously destroyed?
Reply With Quote Reply with Nested Quotes
  #2  
Old 2010-12-11, 05:44 PM
paddington's Avatar
paddington paddington is offline
crumpet-stuffer
TTD Staff
87.48 GB/884.33 GB/10.11
 
Join Date: Jan 2005
Location: UK
Re: Question about weird looking wave

the setting you are asking about is "normalize" and is common on many CD burning programs. It should never be used.

however, I don;t think that is what was done here.
Generally, unless it sucks ass, a normalization algorithm will simply boost the modulation until the loudest sound peak hits 99% (or however you set it) which has the effect of bringing ALL the audio up the same amount - until that loudest peak hits max, then the amplification stops.

The only way for that process to modify the wav in a manner that matches your post is for some jackass to only normalize that quiet section as a separate selection, rather than the whole song / tape at once, as it should be done.

I do not think that was done, here.


That said, if they ran it through a limiter (which would not be part of a CD Burning app), the limiter, with enough drive, would do pretty much what you have there... notice the removal of the dynamics during the song and the huge amp of the banter sounds.
Limiting basically jacks up the volume of the wav, but limits how high it can reach, absolutely. A "line" is drawn and any audio peaks that go over are clipped off, so the loudest sounds never get louder, but the softest sounds come way up (depending on how much you drive it).

In effect, the dynamic range (difference between the softest and loudest sounds) is decreased, which looks to be exactly what has happened to your audio, here.
__________________
"There are some of these recordings where it is just a whirring, and you cannot hear the music. " - Jimmy Page, 2007 / JUL / 26
Reply With Quote Reply with Nested Quotes
  #3  
Old 2010-12-11, 05:47 PM
AAR.oner's Avatar
AAR.oner AAR.oner is offline
TTD Staff
1.11 TB/1.41 TB/1.27
 
Join Date: Feb 2005
Re: Question about weird looking wave

looks like they mighta used a compressor with normalization...few other possibilities as well, impossible to tell by just lookin at a wave form...I don't know of a CD extraction prog that'd do it automatically but its possible I guess
__________________
TTD's Gear Lust Forum -- info & reviews on taping gear
The Basics of EQing
Reply With Quote Reply with Nested Quotes
  #4  
Old 2010-12-11, 06:50 PM
rspencer's Avatar
rspencer rspencer is offline
TTD Hoarder
TTD Staff
326.11 GB/317.06 GB/0.97
 
Join Date: Oct 2007
Location: the outer limits
Re: Question about weird looking wave

Quote:
Originally Posted by jameskg View Post
the setting you are asking about is "normalize" and is common on many CD burning programs. It should never be used.
While a common belief, this is incorrect. Or, at the least, too ambiguous to be useful.

Normalization can & often should be used, as long as it is "peak" normalization...which is basically what you go on to describe. The source is scanned, and then amplified so that the highest peak reaches a predetermined level (e.g., -0.1 dB). If the highest peak is -6 dB, then the entire wave would be amplified by 5.9 dB. This increases the volume while maintaining the dynamic range.

The "bad" normalization is "RMS" normalization. It sets the RMS average to a predetermined level, compressing any over peaks. This squashes the dynamic range. While many consider it "bad," it does have its uses and is sometimes the better way to go, but most often not.

While the second pic could illustrate normalization using a limiter, I don't think that's the case. The peaks are not as uniform as one would expect had a limiter been used. It looks to me more likely RMS normalization.
__________________
My main list .... My masters

Quote:
Originally Posted by dcbullet View Post
Sometimes im dense.
Quote:
Originally Posted by dcbullet View Post
I hate not being a real man.
Reply With Quote Reply with Nested Quotes
  #5  
Old 2010-12-11, 08:33 PM
paddington's Avatar
paddington paddington is offline
crumpet-stuffer
TTD Staff
87.48 GB/884.33 GB/10.11
 
Join Date: Jan 2005
Location: UK
Re: Question about weird looking wave

I've never seen an RMS normalizer - either software or hardware... isn;t that pretty much just a compressor?
__________________
"There are some of these recordings where it is just a whirring, and you cannot hear the music. " - Jimmy Page, 2007 / JUL / 26
Reply With Quote Reply with Nested Quotes
  #6  
Old 2010-12-11, 10:33 PM
rspencer's Avatar
rspencer rspencer is offline
TTD Hoarder
TTD Staff
326.11 GB/317.06 GB/0.97
 
Join Date: Oct 2007
Location: the outer limits
Re: Question about weird looking wave

It's a feature in most audio software. Sound Forge, Audacity, Pro Tools...

Compression is often a facet of it, yes, but not necessarily.


I have used it; it has been the best option in certain situations. For example, in a show with not a wide dynamic range, say an acoustic solo performer, the greatest dynamic range will be the applause vs. the performer. So I raised the RMS level to get a good peak level, along with compressing the applause. It loses the dynamic range, but it wasn't preferable in a case like that.
__________________
My main list .... My masters

Quote:
Originally Posted by dcbullet View Post
Sometimes im dense.
Quote:
Originally Posted by dcbullet View Post
I hate not being a real man.
Reply With Quote Reply with Nested Quotes
  #7  
Old 2010-12-13, 10:28 AM
roann's Avatar
roann roann is offline
TTD Staff
1.24 TB/594.30 GB/0.47
 
Join Date: Nov 2004
Location: Planet Earth
Re: Question about weird looking wave

I'm pretty sure this was caused by a compressor. It basically allows you to boost nearly anything that's lower than the highest peak to that maximum - if you a) have no clue how to use the compressor software properly, and b) cannot hear anything (even Pete Townsend will tell you how bad such a butchered recording sounds).

Using a compressor that moronic way the dynamic range will go down to zero. That's why you cannot get the second wave with normalisation. As said above this increases the volume with a given level while maintaining the dynamic range.
Reply With Quote Reply with Nested Quotes
  #8  
Old 2010-12-16, 01:47 AM
Five's Avatar
Five Five is offline
189.30 GB/594.78 GB/3.14
 
Join Date: Oct 2004
Location: Canada
Re: Question about weird looking wave

Quote:
Originally Posted by rspencer View Post
While a common belief, this is incorrect. Or, at the least, too ambiguous to be useful.

Normalization can & often should be used, as long as it is "peak" normalization...which is basically what you go on to describe. The source is scanned, and then amplified so that the highest peak reaches a predetermined level (e.g., -0.1 dB). If the highest peak is -6 dB, then the entire wave would be amplified by 5.9 dB. This increases the volume while maintaining the dynamic range.

The "bad" normalization is "RMS" normalization. It sets the RMS average to a predetermined level, compressing any over peaks. This squashes the dynamic range. While many consider it "bad," it does have its uses and is sometimes the better way to go, but most often not.

While the second pic could illustrate normalization using a limiter, I don't think that's the case. The peaks are not as uniform as one would expect had a limiter been used. It looks to me more likely RMS normalization.
biggest thing to pay attention to is that the 'normalization' is applied to the show as a whole, based on the highest peak of the entire program material. otherwise the volume changes at every cue stop & is really annoying. not sure if any progs do this anymore, iirc nero used to do this shit



for the original question of the thread, it looks like compressor to me as well.
__________________
Checksums Demystified | ask for help in Technobabble

thetradersden.org | ttd recommended free software/freeware webring
shntool tlh eac foobar2000 spek audacity cdwave vlc

Quote:
Originally posted by oxymoron
Here you are in a place of permanent madness, be careful!
Reply With Quote Reply with Nested Quotes
  #9  
Old 2010-12-16, 03:01 PM
rspencer's Avatar
rspencer rspencer is offline
TTD Hoarder
TTD Staff
326.11 GB/317.06 GB/0.97
 
Join Date: Oct 2007
Location: the outer limits
Re: Question about weird looking wave

NERO burning app will do that if you check "normalize files." I've only used it maybe once or twice, just burning mix discs for the car. It scans & normalizes each track individually.

NERO wave editor, however, will do it as a whole file if that's what you highlight (just like any other editor).
__________________
My main list .... My masters

Quote:
Originally Posted by dcbullet View Post
Sometimes im dense.
Quote:
Originally Posted by dcbullet View Post
I hate not being a real man.
Reply With Quote Reply with Nested Quotes
Reply

The Traders' Den > Where we go to learn ..... > Technobabble

Similar Threads
Thread Forum Replies Last Post
Clipping in wave files--question - Lou Technobabble 3 2005-03-30 06:01 PM


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forums


All times are GMT -5. The time now is 10:12 AM.


Powered by: vBulletin, Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - , TheTradersDen.org - All Rights Reserved - Hosted at QuickPacket