|
Lossy or Lossless? Please use this forum to post spectral and frequency analysis posts about shows you have your doubts about. |
|
Thread Tools |
#1
|
|||
|
|||
Minidisc recordings - lineage
I have a few shows I'm considering uploading that were recorded on Minidisc between 2004 and 2009 (I only moved to a WAV recorder in 2010 - don't judge me) and some bootleg tapes I bought from Camden Market (which I would assume are lowgen as the guys who ran the stalls were tapers)
Would the following be acceptable lineages for shows not available elsewhere and what additional info would be required. I'd adjust levels in Pyro Audio Creator in each example? 1 MD -> WAV (direct transfer to Edirol R07) -> FLAC 2 MD -> CDR (direct transfer to standalone Philips CDR) -> EAC to WAV -> FLAC frontend 3 CASS bootleg (From Camden Market) -> WAV (direct transfer to Edirol R07) -> FLAC No members have liked this post.
|
#2
|
||||
|
||||
Re: Minidisc recordings - lineage
You should include the MD unit/model used to record and/or transfer the shows. Also, unless they are Hi-MD and lossless PCM recordings, anything after 2008/01/01 is not allowed here if its regular Net-MD. Taped before 2008/01/01, it should be fine.
And for the cassettes, doesn't hurt to include the type of tape. Say which deck model was used to transfer it, whether there was Dolby or No Dolby, etc. EDIT: January 1st, 2008 Last edited by LeifH12345; 2020-12-26 at 12:06 PM. Reason: md ban date |
#3
|
||||
|
||||
Re: Minidisc recordings - lineage
Here's what each lineage should look like:
1) Which mic (if known) > MD unit (model if known) > Brand of blank MD > MD Deck used to transfer (Model if known) > R-07 > Pyro Audio Creator > Flac (which program used to encode - Frontend?) 2) Which mic (if known) > MD unit (model if known) > Brand of blank MD > MD Deck used to transfer (Model if known) > CDR (direct transfer to standalone Philips CDR) -> EAC to WAV -> FLAC frontend 3) Cassette Bootleg from Camden Market (audience/sbd/fm, brand of tape, type 1 or 2, dolby, etc) > Cassette Deck (which model, dolby, etc) > R-07 (16 bit? 24 bit? ) > Pyro Audio Creator > Flac Frontend (?) No members have liked this post.
|
#4
|
||||
|
||||
Re: Minidisc recordings - lineage
What Leif said, except the cutoff date 2008-01-01. From the FAQ:
Quote:
No members have liked this post.
|
#5
|
|||
|
|||
Re: Minidisc recordings - lineage
Quote:
Thank you for the clarification and the pointer to the additional info in the FAQ which I hadn't seen. I had a few 2008/9 MD recordings - but wasn't sure whether the rule, which I'm guessing was made to try and dissuade new MD recordings at the time, was still applicable given the passage of time. I'll stick to recordings that follow the rules. No members have liked this post.
|
The Traders' Den |
Thread Tools | |
|
|