Record settings for iriver10?
hey there, Ive got rockbox installed and working fine on my iriver h10 6gb. Im going to a concert tomorrow and want to record the audio. Last time I did this the audio turned out really distorted. What settings do you recommend I use to get a better sounding recording?
My current rockbox sound settings:
volume: 6 DB. should I set it to 0 db or -74 db, i dont understand this
gain: 20 DB
bass: 0 DB
treble: 0 DB
balance: 0%
channel configuration: stereo
stereo width: 100%
crossfeed: crossfeed No
equalizer: off. simple eq settings: 60 hz band gain
dithering: no
timestretch: no
limiter preamp: 0 db
recording settings:
format: PCM Wave
frequency: 48 kHz
source: microphone... line in, whats line in? I dont have a mic jack on my device only headphone jack, could i use headphone jack for external mic?
channels: stereo
mono mode: mono left + right
file split options: split measure
prerecord time: off
clipping light: off
trigger: off, trigtype: stop, prerecord time: off, start above: -35db
peak release: 8 unuts/10ms
peak hold time: 500ms
clip hold time: 60
clip counter: no
scale: (db)
min of range: -60db
max of range: 0db
these are default settings, i will be in an indoor arena which holds about 20,000 people. I will be in the lower section seating. the stage is sort of centered but not completely
would appreciate if you could help me with my settings
No members have liked this post.
|