View Single Post
Old 2005-05-25, 09:14 PM
Re: tricky manual SBE removal

I think you are making this job more difficult than is necessary. I don't see why you are messing about with a spectrum view of the wave. Just zoom on in with your wave editor in edit or wave mode (like the view I posted above) and snip out the zero samples. It's easy.

I do this with EAC. I just zoom in and cut out the middle part of the gap, leaving just enough at either end that when I zoom in a bit more, I can still tell where the gap is. Then I zoom in so that I can see each individual sample and I cut out all the zero samples. That's all it should take.
Reply With Quote Reply with Nested Quotes