PDA

View Full Version : lineage question


Drgiggles1
2010-09-28, 08:23 AM
if you see analog master > DAT > DAT is this interpreted as DAT[0] > DAT[1] or DAT[1] > DAT[2]. I am assuming the first choice since the master is analog prior to the first DAT. Which is correct ? I just want to make sure... Thank you in advance.

paddington
2010-09-28, 08:31 AM
I think I'd only use DAT(0) if the DAT was the master. Even going to DAT, there's an analog generation because you're playing the analog master through analog circuitry and raising the noise floor a bit / adding a tad of wow and flutter when dubbing to DAT.

not sure there's any right answer, though.

freezer
2010-09-28, 08:46 AM
.........
not sure there's any right answer, though.

:clap: :clap: :clap: :clap: :clap:

:thumbsup

paddington
2010-09-28, 08:54 AM
Currently Active Users Viewing This Thread: 3 (3 members and 0 guests)
jameskg (http://www.thetradersden.org/forums/member.php?u=11292), freezer (http://www.thetradersden.org/forums/member.php?u=9323), jarrod (http://www.thetradersden.org/forums/member.php?u=323712)

:wave: jarrod

dcbullet
2010-09-28, 12:55 PM
Maybe just leave it like this: master C > DAT > DAT